10 Hours Service - Cyclonefilter; 10 Hours Service - In-Line Filter; 10 Hours Service - Nozzle Filters - Hardi NAVIGATOR Classic EAGLE 3000 Instruction Book

10 Hours Service - CycloneFilter

Servicing the Filter
1. Turn the pressure SmartValve towards
2. Unscrew the filter lid (A).
3. Lift lid and filter (B) out of the housing.
4. Turn the two locks (C) outwards to unlock the filter from the lid.
5. Separate the filter from the integrated filter guide in the lid.
6. Clean the filter.
To Reassemble
1. Grease the two O-rings on the lid/filter guide. Due to small space
at the lid, use a paintbrush to apply the grease.
2. Fit the filter onto the recess (do not grease the recess) in the
lid/filter guide.
3. Turn the two locks (C) inwards to lock the filter into position.
4. Place the filter/filter lid into the housing and screw the lid, until it
hits the stop.
±
WARNING! Always wear protective clothing and gloves, before servicing the filter!
€
DANGER! Always turn the pressure SmartValve to
In addition, turn the boost valve (D) to the closed position.
Otherwise, spraying liquid may hit you when opening the filter and this will also drain the MainTank!

10 Hours Service - In-Line Filter

If the boom is equipped with In-Line filters, unscrew the filter bowl to
inspect and clean the filter. When reassembling, always grease the O-
ring.
Alternative filter meshes are available. See the section "Filters" on
page 163.
±
WARNING! Be careful not to splash out liquid, when unscrewing
the filter bowl.
Always wear protective clothing and gloves, before servicing the
filter!

10 Hours Service - Nozzle Filters

The filters are located in the nozzle holder.
Check the filter condition and clean the filter.
.
, before opening the CycloneFilter!
6 - Maintenance
125