View The System Information (System Info) - ITech IT6000D Series User Manual

5.14 View the System Information (System Info)

This menu item is used to view the system information of the instrument.
The procedures to view the system information are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
2. Press the Up/Down key or turn the knob to select the System Info and press
Category Parameter
Parallel
Config Mode
menu
Speed
V-Rise Time/I-Rise Time
V-Fall Time/I-Fall Time
Output Res
On Delay/Off Delay
Protect OVP/OCP/OPP/UCP/UVP Sta-
menu tus switch
OVP/OCP/OPP Protection point:
Level
UCP/UVP Protection point:
Level
OVP/OCP/OPP/UCP/UVP Delay
time: Delay
UCP/UVP Warm time: Warm-up
ter the system menu.
[Enter].
Copyright © Itech Electronic Co., Ltd.
Basic Operation
Initial Value
•
IO–4: Ext-Trig
•
IO–5: INH-Living
•
IO–6: Sync-On
•
IO–7: Sync-Off
Single
CV
High
0.1s
1000
0
Off
Rated voltage / current /
power value of the
instrument
0
60s
120