ITech IT6000D Series User Manual page 60

Error message
Config Data Lost
NETWORKING...
FIBER MULTI MASTER
FIBER EXT UNLOCK
FIBER INNER UNLOCK
Exception Handling
If the instrument cannot start normally, please check and take measures by
reference to steps below.
1. In order to facilitate the transportation and protection of the fiber optic cable,
2. Check whether the power cord is correctly connected and confirm whether
3. Check whether the power in On. The power switch is under "|" On status.
4. Check whether the power voltage matches with the supply voltage. Please
5. After multiple units are connected in parallel and powered on, the error re-
the fiber optic cable required for communication between the two single units
(one master and one slave) of the 6U model is removed at the factory and
packaged separately as an accessory. Before you turn on the power of the
device, you need to connect the fiber cable as shown in the figure below,
and then perform the power-on operation.
the instrument is powered.
refer to 2.4 Connecting the Power Cord
lated to the fiber-optic is indicated. Please refer to the following steps for
troubleshooting.
Copyright © Itech Electronic Co., Ltd.
Error Description
The latest operation state of the in-
strument is lost.
The parallel operations are abnormal
and cannot finish the networking.
Multi-master conflict
The outer ring of the fiber is not
locked.
The inner ring of the fiber is not
locked.
to select proper AC input.
Getting Started
49