Racelogic Touch V2 Quick Start Manual page 28

Load a Reference Lap
You can load a previously saved or provided reference lap by pressing the Load button (as long as the unit is not
logging and the vehicle is not moving). If an SD card is detected, the unit will display all .ref files located within the REF
LAPS folder on the SD card. Select a file and press the Confirm button at the bottom right of the screen to confirm your
selection. Press the Cancel button at the bottom left of the screen to return to the Settings screen without saving.
If confirmed, the unit will briefly display a load success screen to show that the file was loaded.
If there are splits stored in the file, these will also be uploaded to the unit (up to 10 gates/splits).
Note: When a new reference lap is loaded, the Start/Finish gate stored in the .ref lap will be applied as the active Lap
timing gate if it is different to the currently loaded gate. If the gates are changed, all existing lap timing values will be
cleared and the new lap timing gates will be used.
Save a Reference Lap
If a reference lap has been created, you can save the lap for future use (as long as the unit is not logging and the
vehicle is not moving). Press the Save button to start the process. If the unit detects an SD card, it will save the file as
'lap.ref' in a REF LAPS folder on the SD card. A save success screen will briefly display to confirm that the file is saved.
If a reference lap file already exists on the SD card, Performance Box Touch will display an overwrite cancel screen,
giving you 5 seconds to cancel the overwrite by pressing on the screen.
Ignore Short Laps
You can choose to ignore short laps from creating
a reference lap. Enabling this feature will let you enter a
minimum lap time that is acceptable to use as a
reference lap.
To change the time, press the corresponding blue value
box and use the presented keypad.
To save your selected value, press the Confirm button at the bottom right of the screen. Press the Cancel
Button at the bottom left of the screen to return to the Settings screen without saving. The default setting is 60 seconds
and the value range is 10 to 86400 seconds. The selected value will be remembered after each power cycle.
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Lap_Timing_Mode_-
Minimum Lap Time Keypad Example
_Performance_Box_Touch_V2
28