Racelogic Touch V2 Quick Start Manual page 23

Lap timing mode performance box

Hide thumbs Also See for Touch V2:

Table of Contents

Gate Width

You can change the width of the Start/Finish line gate by

pressing on the value box and using the presented

keypad.

To save your chosen width, press the

Confirm button at the bottom right of the screen. Press

the Cancel button at the bottom left of the screen to

return to the Settings screen without saving. The default

setting is 25 m / 82 ft and it is selectable from 3 to 100 m

/ 10 to 330 ft. The value will be remembered after each

power cycle.

Note: You can enter the width with up to 1 decimal

place.

This option is particularly useful if Performance Box Touch is not detecting the correct number of laps. When racing at a

very narrow circuit where the pit lane is right next to the start line, it could be possible to trigger lap timing in the pit lane,

giving an incorrect number of laps.

Rolling Lap Time

If you enable Rolling Lap Time, both Lap Timing Screens will display the current live lap time. When a new lap starts, the

previous lap time will be displayed for 5 seconds before it reverts to display the current live lap time. When it is disabled,

it will only display the previous lap time.

Note: This feature is enabled by default.

https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/

Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Lap_Timing_Mode_-

Gate Width Keypad Example

_Performance_Box_Touch_V2

Table of Contents

Pbt-v2 Rlpbt-v2