Racelogic Touch V2 Quick Start Manual page 17

How to Manually Set a Separate Finish Line
You can set a separate finish line manually when
moving. This will overwrite the finish line detected in the
circuit layout.
To manually set a finish line, tap the screen when on
the Basic Lap Timing Screen if you have
enabled Standing Start or select Set Finish Gate in the
Settings.
A screen will be displayed, allowing you to cancel the
finish line gate set within 5 seconds by repressing the
screen. After the 5 seconds have passed, you are
required to drive forward in a straight direction to
complete the process. The gate is set at 90° to the
detected heading and the width depends on what you
have selected in the Gate Width Settings.
The detected location when the screen is initially
pressed/finish gate set is used as the centre point of the
finish gate.
You must set a separate finish line if you are using
Standing Start Mode.
Notes:
• To set a Start/Finish line, the vehicle must be moving >0.8 km/h and the Performance Box Touch must have a
satellite lock.
• If the setting of the start/finish line is cancelled, any live lap prediction for the current lap will be lost and unavailable
for use.
Creating a Reference Lap
A reference lap is required for Performance Box Touch to calculate Delta-T and Delta-V lap timing values. Performance
Box Touch will automatically begin to create a reference lap once the Start/Finish line is crossed or it detects movement
in Standing Start mode, and will complete it when the Start/Finish line is crossed again or when the separate Finish
Line is crossed.
Requirements for creating a reference lap:
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Lap_Timing_Mode_-
New finish line cancellation screen
_Performance_Box_Touch_V2
17