Racelogic Touch V2 Quick Start Manual page 22

existing track information.
The progress of the track database update will be displayed via the LEDs; each lit LED will represent 25% of the
process with all LEDs extinguishing when the process is complete.
Lap Timing Gates
Load Start/Finish or Finish Line Gates
You can load previously saved or provided Start/Finish line gates by inserting an SD card with gate files contained
in an SF LINES folder into the unit and pressing the Load Lap Timing Gates button in the Lap Timing Settings.
If the unit can only find one file on the SD card, the file will be loaded immediately.
If multiple files are located on the SD card, the unit will display all available files. Select a file and press the
Confirm button at the bottom right of the screen to confirm your selection. Press the Cancel Button at the bottom left
of the screen to return to the Settings screen without saving.
When loaded, a success screen will briefly display to show that the file was loaded successfully. If there are splits stored
in the file, these will also be uploaded to the unit (up to 10 gates/splits).
Note: When a new Start/Finish or Finish line gate is loaded, all existing lap timing values will be cleared and the new lap
timing gates will be used.
Save Start/Finish Gates
To save the currently defined Start/Finish gates, press the Save Lap Timing Gates button in the Lap Timing Settings.
If the unit detects an SD card, it will save the file as gates.spl in an SF LINES folder on the SD card. A save success
screen will briefly display to show that it was saved. If a gate file (named gates.spl already exists on the SD card,
Performance Box Touch will display an overwrite cancel screen. This screen gives you 5 seconds to cancel the
overwrite by pressing anywhere on the screen.
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Lap_Timing_Mode_-
_Performance_Box_Touch_V2
22