Racelogic Touch V2 Quick Start Manual page 20

If the layout has changed, the LEDs will briefly flash green twice and the unit will emit an audible confirmation
notification. The layout will be remembered after each power cycle if it is determined to be local to the detected location.
Note: When the selected track is changed, all existing lap timing values will be cleared and new lap timing gates will be
used.
Set Start/Finish Gate
Selecting the Set Start Gate option in the Lap Timing Settings will manually set a start/finish line when moving, and
will overwrite the detected line in the circuit layout. If you are defining a separate Finish Line, the set start/finish gate will
act as the Start Line only.
Note: The vehicle must be moving >0.8 km/h and the unit have a satellite lock to set a Start/Finish Line.
Set Finish Gate
Selecting the Set Finish Gate option in the Lap Timing Settings will manually set a Finish line when moving, and will
overwrite the detected finish line in the circuit layout. You must set a separate finish line if you are using Standing Start
Mode.
Note: The vehicle must be moving >0.8 km/h and the unit have a satellite lock to set a Finish Line.
Clear Finish Gate
(Only selectable if a Finish gate has been set)
https://en.racelogic.support//Product_Info/Performance_Meters/Performance_Box_Touch/Performance_Box_Touch_V2/
Quick_Start_Guide_%E2%80%93_Performance_Box_Touch_V2/Quick_Start_Guide%3A_Lap_Timing_Mode_-
_Performance_Box_Touch_V2
20