Sliding Roof: Clean And Lubricate Runners - Skoda Octavia II 2004 Maintenance Manual

– Adjust the windscreen wiper arm at a distance -a- of approx.
35 mm from the lower edge of the rear window.
The specified tightening torque for the windscreen wiper nut is 8
Nm.
– Inspect setting of nozzle, if necessary adjust with a tool, e.g.
with a needle.
The spray should strike the rear window as shown in the illustra‐
tion when the vehicle is stationary.
Note
If the spray flows out unevenly, or if it cannot be adjusted, replace
the spray nozzle (repair measure).
Replacing the rear window wiper blade
Removing the wiper blade
– Fold away windscreen wiper arm from the windscreen and
align the wiper blade horizontally.
– Hold the windscreen wiper arm in the top part with one hand.
– Unlock button -1- with the second hand in direction of arrow
and remove the wiper blade.
Attaching the wiper blade
– Push the wiper blade onto the windscreen wiper arm and lock
the button -1-.
– Check whether the wiper blade is correctly attached.
Note
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
There is a risk of damage to the rear window by the windscreen
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
wiper arm, if the windscreen wiper is improperly handled.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
7.5

Sliding roof: clean and lubricate runners

– Carry out a visual inspection of the sun roof for leaks and cor‐
rosion damage
– Clean the runners -1- and grease with lubricant -G 052 778
A2- .
– Inspect proper operation of the sun roof, pay attention to pos‐
sible abrasive residue.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
175
7. Body