Skoda Octavia II 2004 Maintenance Manual page 65

– Unscrew the rubber bowel -arrow- from the oil filter housing.
– Screw the adapter -T40057- into the oil filter housing and hold
the hose in the oil catch pan.
Note
When screwing in the adapter -T40057- the valve is opened
♦
in the oil filter housing.
When unscrewing the adapter -T40057- the valve is automat‐
♦
ically closed again.
– Drain the engine oil.
– Unscrew adapter -T40057- .
– Now unscrew the oil filter housing using oil filter wrench -3417-
or wrench 36.
Install replacement oil filter element
– Replace oil filter insert -4- as well as gasket ring -3-.
Note
before fitting moisten gasket rings lightly with clean engine oil.
♦
Observe the disposal instructions!
♦
– Tighten oil filter housing -2- to 25 Nm.
– Screw rubber bowl -1- by hand into the oil filter housing -2-.
– Install the noise insulation.
3.8.2 Replace oil filter with replacement oil fil‐
ter for petrol engines
Oil filter wrench e.g. 3417 , or wrench 32 or 36 (except for 1.4 ltr/
59 kW engine)
– Loosen oil filter and unscrew:
Remove sound dampening system for filters attached laterally
to the motor.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
61