Skoda Octavia II 2004 Maintenance Manual page 66

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
Remove engine trim panel for filters attached to the motor from
above.
Install new replacement oil filter
– Clean sealing surface at engine.
– Lightly moisten the rubber seal of the oil filter with oil.
– Screw in the new oil filter.
– Tighten the oil filter as follows:
1.8 ltr/112, 1.8 ltr/118 kW engines: 20 Nm
All other engines: tighten by hand.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
– Install the engine cover.
3.8.3 Replace oil filter for diesel engines
Special tools and workshop equipment required
♦ Oil filter wrench or wrench 36 or 32
– Remove engine cover.
For TDI CR (Common Rail) engines
– Unscrew the plug -arrow-.
– Slacken solenoid valve -1- with holder and place to the side.
– Slacken cable -2- and place to the side.
Continued for all vehicles
62
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�