Skoda Octavia II 2004 Maintenance Manual page 131

– Provide a catch pan for used brake fluid.
Note
Use the tool set for brake bleeding - VAS 6564- to loosen and
♦
tighten. While doing so, pull the bleeder hose through the
socket insert with a corresponding hollow adapter piece from
this set.
Fit a torque wrench on the socket insert with a corresponding
♦
hollow adapter piece for tightening the vent valve.
In view of the different versions and the fitting locations of the
♦
slave cylinder with the vent valve, tightening the vent valve
using the set of tools for brake bleeding - VAS 6564- (with the
torque wrench inserted) cannot always be performed due to
lack of space.
In this case, if necessary remove the battery and the battery
♦
tray ⇒ Electrical System; Rep. gr. 27 . Pay attention to the
work sequence when disconnecting and reconnecting the bat‐
tery ⇒ Electrical System; Rep. gr. 27 .
– If necessary remove cap from bleeder valve of slave cylinder.
Gearbox 0A4
– Fit the bleeder hose of the catch pan onto the vent valve of the
slave cylinder -arrow-.
Gearbox 0AJ
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Fit the bleeder hose of the catch pan -arrow- onto the vent
valve of the slave cylinder.
Gearbox 02Q
Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
127
5. Chassis