Skoda Octavia II 2004 Maintenance Manual page 124

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
– Ensure that the valve -arrow- is closed.
– Screw oil reservoir onto filling device -VAS 6291- .
– Open valve -arrow- and hold oil reservoir as shown.
The four-wheel drive clutch is now filled with oil.
– Raise the vehicle after several minutes.
Note
If the four-wheel drive clutch is correctly filled, oil flows out at
♦
the adapter -A-.
If no oil flows out, lower the vehicle and continue the filling
♦
procedure.
– Raise vehicle.
– If oil flows out, place oil reservoir downwards below the line of
the four-wheel drive clutch (e.g. on a tool car).
The excessive oil now flows back into the oil reservoir.
– If no more oil flows back, remove filling device -VAS 6291- .
– Check oil level in the four-wheel drive clutch.
– Screw in screw -arrow- using a new sealing ring and tighten
to 15 Nm.
120
4. Gearbox
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�