Select Language In The Dash Panel Insert - Skoda Octavia II 2004 Maintenance Manual

Resetting service interval display (SID) with -VAS-
WARNING
This work sequence cannot be carried out on vehicles, for
which no service message or only a pre-warning was displayed
on the display of the dash panel insert.
Vehicles up to MY 2012:
♦ Vehicles with service intervals -QG1- are automatically
recoded to -QG2- as a result of this procedure.
♦ A reverse recoding to -QG1- can only be performed with
-VAS- ⇒ Vehicle diagnostic tester
⇒ "6.9 Changing the code of the service intervals",
page 162 .
Vehicles as of MY 2013:
♦ Vehicles with service intervals -QI6- are automatically re‐
coded to -QI4- as a result of this procedure.
♦ A reverse recoding to -QI6- can only be performed with -
VAS- ⇒ Vehicle diagnostic tester
⇒ "6.9 Changing the code of the service intervals",
page 162 .
Vehicles without an information display:
– Press the set button on the dash panel insert.
– Switch on ignition.
– Slightly turn the set button.
Vehicles with an information display:
– Switch on ignition.
– Hold the button -A- on the windscreen wiper lever or multi-
functional steering wheel pressed for longer than 1 second.
Thereby the »MAIN MENU« is shown in the information dis‐
play, at the same time observe the instructions on vehicles
with the Škoda information system (as of MY 09)
⇒ page 160 .
– Select option »Setup« with the button -B-, briefly press this
button and then select the option »Service interval« and then
the option »Reset«.
6.8

Select language in the dash panel insert

For all vehicles
The language in the dash panel insert is selected with the vehicle
diagnosis, measurement and information system -VAS- .
Octavia II 2004 ➤ , Octavia II 2010 ➤
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Maintenance - Edition 01.2018
6. Electrical System
161