Skoda Octavia II 2004 Maintenance Manual page 60

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
– Loosen the screw cap for the oil filter -1- and keep in this po‐
sition for a few minutes to allow the engine oil to flow out of the
filter element and filter housing.
– Unscrew the screw cap for oil filter -1- and remove the oil filter
element -3-.
– Remove oil filter element -3-.
For all vehicles
– Suction off the engine oil with the old oil collection and suction
device
or
– Remove noise insulation (unless removed already).
– Screw out the oil drain plug and collect the oil in a suitable
vessel.
Note
Always replace oil drain plug.
– Screw in drain plug using a new sealing ring and tighten to 30
Nm.
– Install new oil filter/oil filter element
⇒ "3.8 Replace engine oil filter", page 59
– Pour in oil as stated in the specifications
56
.
⇒ page 57 .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�