Skoda Octavia II 2004 Maintenance Manual page 115

– Lever off cap -arrow- securing the screw plug with a screw‐
driver.
Note
The filler tube is located at the front of the gearbox under the
starter.
– Always replace the cap, because the cap catch is destroyed
⇒ Electronic Catalogue of Original Parts .
– Pull off screw plug from the filler tube.
– Hook the hook of the ATF filling system - V.A.G 1924- into the
opening of the filler tube.
Note
Too much or too little ATF filling impairs the gearbox function.
– Fill ATF with -V.A.G 1924- , until ATF between a temperature
of 35 °C and 45 °C flows out of the inspection opening via the
overflow tube -arrow 2-.
– Allow all excess ATF to drip out until it starts to drain off.
– Fit ATF inspection plug -arrow 1- with a new gasket ring and
tighten to 27 Nm. This completes the ATF topping up.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
111
4. Gearbox