Skoda Octavia II 2004 Maintenance Manual page 85

– If the limit value of the ash mass is reached or exceeded, the
diesel particle filter has to be replaced ⇒ Relevant Engine;
Rep. gr. 26 .
Replacing the diesel particle filter is a repair measure.
Note
After replacing the diesel particle filter, perform »adaption of the
engine control unit after replacing diesel particle filter«, i.e. set the
limit value for the ash mass to -0-.
TDI Common Rail engines (1st and 2nd generations):
– Select »Targeted functions« and further »engine« and then
start »check volumetric efficiency of the particle filter volume«
⇒ Vehicle diagnostic tester.
– If the ash mass limit is reached or exceeded (negative test
result), the diesel particle filter must be replaced ⇒ Relevant
Engine; Rep. gr. 26 .
Replacing the diesel particle filter is a repair measure.
Note
After replacing the diesel particle filter, perform »adaption of the
engine control unit after replacing diesel particle filter«, i.e. set the
limit value for the ash mass to -0-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
81