Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
Note
Because LPG is heavier than air, it will always settle to the
♦
bottom. For this reason, the tightness below a screwed con‐
nection must be primarily checked on 2 points at a distance of
90° -arrows-.
Then check tightness above the screw connection in the same
♦
way. Or slowly guide the measuring tip around the entire screw
connection.
Check all of the screwed connections of the gas system!
♦
– Slacken the screws of the protective cover for the LPG reser‐
voir in the spare wheel well -arrows- and remove the cover
-1-.
Note
Do not damage the seals for the protective cover and the screws.
– Start engine, switch to LPG operation and run in idle.
– Use the gas leakage detector for natural gas vehicles to check
if leaks can be found:
Inspection position
90
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�