Skoda Octavia II 2004 Maintenance Manual page 64

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
– Light knock the screw cap for the oil filter with the oil filter el‐
ement holder -1- on a fixed base -3- (e.g. a wooden plate)
-arrow-.
This loosens the oil filter insert -2-.
– Place the screwdriver carefully in the groove -arrow- of the
screw cap for the oil filter and plug off the O-ring.
Install new replacement oil filter element
– Replace O-rings -2-.
– Insert new oil filter element -3-.
– Screw in the screw cap for oil filter -1- and tighten to 25 Nm.
– After filling with oil, run engine until it is at operating tempera‐
ture and inspect for tightness.
Version of the replacement oil filter insert on the engine from be‐
low
Special tools and workshop equipment required
♦ Oil drainage adapter -T40057-
♦ Oil filter wrench -3417- or wrench 36
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
Remove replacement oil filter element
– Remove the noise insulation.
60