Skoda Octavia II 2004 Maintenance Manual page 118

Octavia II 2004 ➤ , Octavia II 2010 ➤
Maintenance - Edition 01.2018
Requirements
• Engine switched off.
• Vehicle in horizontal position, all supports of the lift platform
must be at the same level, so that it is secured in the horizontal
position.
• Selector lever in ,,P"
• -VAS- is connected.
• The gearbox oil temperature must not exceed 35°C at the start
of the test.
• It is important not to mix up the drain screw -A- with the check
screw -B- (only on gearboxes until 12.04). The check screw
-B- is located close to the pendulum support.
Change the gearbox oil, replace the oil filter
Note
The following instructions must be observed until termination of
the gear oil change.
Removing and installing oil filter
– Remove engine cover ⇒ Relevant Engine ; Rep. gr. 10 .
– Unplug connector -2- at air mass meter -G70-
– Detach bleeder hose -1- and air guide hose -5-.
– Release spring clip -3- with pliers for spring clips and discon‐
nect air guide hose from pipe.
– Release screw -4- and remove air filter housing.
– Remove battery ⇒ Electrical System; Rep. gr. 27 .
– Remove battery ⇒ Electrical System; Rep. gr. 27 .
– Raise vehicle.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Position the catch pan under the gearbox.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
– Lower the vehicle.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
114
4. Gearbox