Additional Materials - Heartland VALUE Series Assembly Manual

• If you purchased a separate floor kit, use instructions and materials in that kit to construct your floor.
• See the FLOOR LEVELING section on page 10 for recommended methods and suggested materials to properly level your floor,
as this will vary depending on your specific site.
• If you will be building your own floor, then below are the materials that you would need.
MATERIAL REQUIRED:
x2
2 x 4 x 12' (5,1 x 10,2 x 365,8 cm)
x10
2 x 4 x 10' (5,1 x 10,2 x 304,8 cm)
Hot Dipped Galvanized Box-Type Nails.
x40
REINFORCED FULL WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! Depending on your specific use you may want to construct a heavy duty floor frame by adding additional floor joists
(shown below as shaded). Below is a list of additional materials (not included):
x3
2 x 4 x 10' (5,1 x 10,2 x 304,8 cm) Treated Lumber
cut to 2 x 4 x 117" (5,1 x 10,2 x 297,2 cm)
x12 3" (7,6 cm) hot-dipped galvanized nails

ADDITIONAL MATERIALS

FOUNDATION OR FLOOR MATERIALS
FULL WOOD FLOOR FRAME (Not Included)
Use only wood treated for ground contact and fasteners approved for use with treated wood.
3" (7,6 cm)
Optional 12" (30,5 cm) spacing
Standard 16" (40,5 cm) spacing
3