Heartland VALUE Series Assembly Manual page 30

PARTS REQUIRED:
BEGIN
Align rafters over the wall studs.
1
Check that you have the measurements shown.
Secure rafters with (2) 3" screws angled at each end (Fig. A, Fig. B).
Secure rafters on opposite side.
Maintain the measurements between rafters.
10' x 12'
24-3/8"
(62 cm)
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel
FINISH
Your rafters are now installed.
RAFTER INSTALLATION
x5
x2
DIMENSIONS ARE FROM OUTSIDE OF WALL PANELS.
DIMENSIONS ARE TO CENTER OF RAFTERS.
24" 24"
(61 cm) (61 cm)
Fig. A
3" (7,6 cm)
Screws angled
into top plate
x28
Two-Gusset
Preassembled
One-Gusset
Preassembled
24"
(61 cm)
ALIGN OVER
STUDS
28
3" (7,6 cm)
24"
24-3/8"
(61 cm)
(62 cm)
Flush to inside
of panel
Fig. B
Rafter with
ONE GUSSET
facing inward.
Flush to
outside
of panel