Additional Materials; Optional Materials - Heartland VALUE Series Assembly Manual

• This shed includes a complete wood floor frame system. It does not include floor panels.
• This shed does not contain any leveling materials.
• See the FLOOR LEVELING section on page 7 for recommended methods and suggested materials to properly level your
floor, as this will vary depending on your specific site.
NOTE: Use a minimum of 5/8" (1,6 cm) Oriented Strand Board (OSB)
x2
REINFORCED WOOD FLOOR FRAME (OPTIONAL)
IMPORTANT! (The included floor is designed for general use.) Depending on your specific use you may want to construct a heavy
duty floor frame by adding additional floor joists (shown below as shaded). Below is a list of additional materials (not included):
x5
2 x 4 x 8' (5 x 10 x 244 cm) Treated Lumber
Cut to (3) 2 x 4 x 93" (5 x 10 x 236 cm)
x20
ea. 3" (7,6 cm) Hot Dipped Galvanized Nails
3-TAB SHINGLES ............................. 5 Bundles
PAINT FOR SIDING .......................... 2 Gallons
Use 100% acrylic latex exterior paint. (2) coats recommended.
CAULK .............................................. 2 Tubes
Use acrylic latex exterior caulk that is paintable.
DRIP EDGE ..................... 50 Feet
REFER TO THE BACK OF THIS MANUAL AND THE MANUFACTURER'S INSTRUCTIONS
FOR INSTALLATION OF SHINGLES, DRIP EDGE AND FELT.

ADDITIONAL MATERIALS

FOUNDATION OR FLOOR MATERIALS
FLOOR PANELS
You will need floor panels and nails to complete your floor.
Floor panel sizes and quantities are shown below.
ACTUAL FLOOR SIZE: 96"' x 116-1/2" (243,8 x 295,9 cm)
5/8" x 48" x96"
(1,6 x 121,9 x 243,8 cm)
Optional 12" (30,5 cm) spacing
COMPLETING YOUR SHED
You will need these additional materials:

OPTIONAL MATERIALS

x1
5/8" x 20-1/2" x 96"
(1,6 x 52,1 x 243,8 cm)
1" GALVANIZED ROOFING NAILS.... 3 Lbs
For shingles.
PAINT FOR TRIM ...........................2 Quarts
Use 100% acrylic latex exterior paint.
WOOD GLUE ....................... Exterior Rated
#15 ROOFING FELT
To cover 93 Sq. Ft. of roof area.
1" GALVANIZED ROOFING NAILS.........1/4 lb
For roofing felt.
4
x1
2" (5,1 cm)
1 lb. of 2" (5,1 cm) Hot Dipped Galvanized
Box-Type Nails.
Standard 16" (40,7 cm) spacing