Heartland VALUE Series Assembly Manual page 34

PARTS REQUIRED:
7/16 x 48 x 96"
x1
(1,1 x 121,9 x 243,8 cm)
Install a 48" x 47-7/8" roof panel flush to the
3
installed panel and flush at peak (Fig. B).
Secure panel with (1) 2" nail in each corner.
4
Move the gable end rafter edge until it
is 1/2" from the 48" x 47-7/8" roof panel
(Fig. C).
Finish securing panel with (2) 2" nails in
the corners.
5
Maintain spacing between the center of the rafters
at the lower edge of the panels (Fig. D).
Secure panels with (1) 2" nail into each rafter,
as shown.
Move to the top of the panel and keep spacing
between the center of the rafters.
Secure panels with (1) 2" nail into each rafter.
24-3/8"
(61,9 cm)
2" (5,1 cm) Nails
10' x 12' ROOF PANELS
NOTE:
Measurements from inside of gable panels
24" 24"
(60,9 cm) (60,9 cm)
2" nails
in each
corner
Fig. D
24"
(60,9 cm)
32
x12
2" (5,1 cm)
Fig. B
Flush
Fig. C
24" 24-3/8"
(60,9 cm)
(61,9 cm)
Flush at
peak
1/2"
(1,2 cm)
Gable
End Rafter