Heartland VALUE Series Assembly Manual page 20

PARTS REQUIRED:
x1
23-7/8" x 84"
(60,6 x 213,4 cm )
2
Install 48" x 84" panel 1-1/2"
from the top plate.
Use a 2x3 spacer for
consistent measurement.
Secure panel with 2" nails
spaced 6" apart on edges
and 12" inside panel.
Note the panel
lip-edge/square edge
orientation.
3
Install the 48" x 84" and (2)
23-7/8" x 84" panels fl ush to
installed panels.
Locate panels 1-1/2" from the
top plate.
Secure with 2" nails spaced 6"
apart on edges and 12" apart
inside panel.
Note the panel
lip-edge/square edge
orientation.
Your fi rst 10' gable wall is
now assembled.
Carefully fl ip the wall over.
Repeat steps to build your
second 10' gable wall.
FINISH
Your (2) 10' gable walls are now assembled.
Carefully fl ip the wall over.
10' GABLE WALL
x2
1-1/2"
(3,8 cm)
48 x 84"
(121,9 x 213,4 cm )
2x3
3/4"
BEGIN HERE
(1,9 cm)
6" (15,2 cm)
12" (30,5 cm)
3/4" Gauge
Block
LIP EDGE
Flush
6" (15,2 cm)
12" (30,5 cm)
Flush
SQUARE
EDGE
18
x136
2" (5,1 cm)
1-1/2"
(3,8 cm)
Flush
Flush
SQUARE
EDGE
23-7/8"
(60,6 cm)
2x3