Intermec IF30 User Manual page 22

Chapter 1 — Getting Started
12
2 With Ethernet selected in the IF30 RFID Reader
Configuration menu, press the right arrow. The Ethernet
menu appears.
3 Configure these settings:
DHCP Mode
Set to
IP Address
A unique IP address.
IP Subnet
The subnet mask that matches the other
Mask
devices in your network.
IP Router
If the IF30 will communicate with devices on
(Gateway)
another subnet, enter the address of the router
that will forward frames.
Or, press the down arrow key to select IPv6 Configuration,
and then press the right arrow key to configure these IPv6
settings:
Enable
Autoconfiguration
IPv6 Address
IPv6 Subnet Mask
IPv6 Router
(Gateway)
4 (Optional) To configure DNS settings, choose Network
Services and press Enter. The Network Settings screen
appears.
Disable DHCP
.
Enables automatic assignment of a
unique address to this IF30.
A unique 128-bit IPv6 address.
The IPv6 subnet mask. Range is 1 to
128 bits.
A unique 128-bit address for an IPv6
router.
IF30 Fixed Reader User's Manual