Printer Setup With Bar Code Wand - Intermec EasyCoder E4 Installation And Operation Manual

Bar code label printer

Hide thumbs Also See for EasyCoder E4:

Table of Contents

Appendix 5

Printer Setup with Bar Code Wand

Connection and

Operation

Important!

The bar codes in this chapter

only work with EasyCoder E4.

In addition to using Intermec Direct Protocol setup strings, the

following setup parameters can also be entered by scanning

pre-printed bar codes with an optional bar code wand:

• Serial port setup

• Print setup

• Media and ribbon setup

To use a bar code wand with the EasyCoder E4:

1 Open the side and front covers.

2 Plug the bar code wand into its socket, to the left of the

printhead area.

3 Touch the bar code wand on the page containing the bar code to

be scanned: the Power LED turns yellow.

4 Pass the bar code wand over the bar code and lift it off the page. If

the bar code has been read correctly, the Power LED turns green.

If the bar code has not been read correctly, the Power LED ﬂ ashes

red before turning green, when you lift the wand.

5 If the bar code has not been read correctly, check that the bar code

wand is properly connected and try again.

Intermec EasyCoder E4 – Installation & Operation Ed. 2

Table of Contents

Do you have a question about the EasyCoder E4 and is the answer not in the manual?