Intermec EasyCoder E4 Installation And Operation Manual page 13

Chapter 3 Operation
Media Load – Tear-Off, cont.
3
Remove any empty cardboard core from the
post. It is not necessary to remove the edge
5
Route the media between the guide rollers,
between the two parts of the ribbon/media
sensor, over the platen roller and out through
the feed-out slot.
12
guide.
4
Check that the media supply roll post is in the
correct position for the size of the media roll.
The post is easier to move if fi rst rotated
a turn. Push the new roll as far in as it will go
and adjust the edge guide.
6
Push the media as far in as it will go and
adjust the edge guide ring according to the
width of the media.
Intermec EasyCoder E4 – Installation & Operation Ed. 2
1
/ of
4