Intermec EasyCoder E4 Installation And Operation Manual page 20

Ribbon Load, cont.
3
Unpack a roll of original Intermec thermal
transfer ribbon.
5
1
2
Press an empty core onto the ribbon rewind
hub (1.) Tape the transparent ribbon leader to
the core (2) and raise the printhead (3.)
Intermec EasyCoder E4 – Installation & Operation Ed. 2
4
20 cm (8 inches)
Press the ribbon roll onto the ribbon supply
spool and route the ribbon under the printhead
with the ink-coated side facing down. Pull out
approx. 20 cm (8 inches) of ribbon and lower
6
3
Both ribbon cores must rotate counterclock-
Chapter 3
the printhead.
wise.
Operation
19