Intermec EasyCoder E4 Installation And Operation Manual page 27

Chapter 4 Printer Setup
Communication
Setup, cont.
In the setup string examples,
a double-headed arrow (as in
"CHAR LENGTH") indicates
a mandatory space characters
in the command line.
Quotation marks (" ") are ASCII
34 dec.
26
By default, the serial port is set for 9600 baud, no parity, 8 data bits,
1 stop bit, XON/XOFF disabled both ways. Note that as soon as a
parameter is changed, you must change the setup of the host the
same way, or the communication will be lost.
• Baud Rate
This setting controls the speed of the serial communication
between printer and host (1 baud = 1 data bit per second.)
There are 8 options:
300 600 1200 2400 4800
Setup string, example:
SETUP "SER-COM,UART1,BAUDRATE,9600"
• Parity
This setting controls how the software will check for errors in the
serial communication. There are 5 options:
None Even Odd Mark Space
Setup string, example:
SETUP "SER-COM,UART1,PARITY,NONE"
• Character Length
This setting controls how many bits are used to specify a character
in the serial communication. There are two options:
7 Characters ASCII 0-127 dec. can be transmitted
8 Characters ASCII 0-256 dec. can be transmitted
Setup string, example:
SETUP "SER-COM,UART1,CHAR LENGTH,7"
• Stop Bits
This setting controls how many bits are used to specify a
stop character in the serial communication. There are two
options:
1 or 2
Setup string, example:
SETUP "SER-COM,UART1,STOPBITS,1"
Intermec EasyCoder E4 – Installation & Operation Ed. 2
9600 19200 38400