Intermec EasyCoder E4 Installation And Operation Manual page 69

Appendix 4 Programming
Command List, cont.
Instruction
PRLINE (PL)
PRPOS (PP)
PRSTAT
PRTXT (PT)
REBOOT
REMOVE IMAGE
SETSTDIO
SETUP
SETUP WRITE
SYSVAR
TESTFEED
TIME$
68
Purpose and Syntax
Draws a solid rectangle.
PRLINE|PL <length>,<line thickness>
Specifes the insertion point for a line of text, a bar code, an image,
a box, or a line.
PRPOS|PP <x-coordinate>,<y-coordinate>
Returns the printer's current status.
(PRSTAT AND <parameter>)
Provides the input data for a text fi eld (a line of text.)
PRTXT[PT "<input data>"[;"<input data>"]
Restarts the printer.
REBOOT
Removes a specifi ed image from the printer's memory.
REMOVE IMAGE "<name>"
Forces selection of standard IN and OUT communication channel.
This is normally automatic.
SETSTDIO <IN channel>,<OUT channel>
Changes the setup by means of a setup string or setup fi le.
SETUP "<setup string>"|"<setup fi lename>"
Creates a setup fi le containing the printer's current setup values or prints
the current setup to the host via the serial port.
SETUP WRITE "<setup fi lename>"|"uart1:"
Reads or sets various system variables.
PRINT SYSVAR(<parameter>)
SYSVAR(<parameter>)=<value>
Slowly feeds media to allow the label stop sensor to adjust itself according
to the presently loaded media.
TESTFEED
Sets or returns the current time, optionally in the format specifi ed by the
FORMAT TIME$ command.
TIME$ = "<HHMMSS>"
PRINT TIME$[("F")]
Intermec EasyCoder E4 – Installation & Operation Ed. 2