Intermec EasyCoder E4 Installation And Operation Manual page 16

Media Load – Peel-Off, cont.
5
Check that the media supply roll post is in the
correct position for the size of the media roll.
The post is easier to move if fi rst rotated
a turn. Push the new roll as far in as it will go
and adjust the edge guide.
7
Push the media as far in as it will go and
adjust the edge guide ring according to the
width of the media.
Intermec EasyCoder E4 – Installation & Operation Ed. 2
6
1
/ of
4
This shows the correct label and liner paths.
8
40 cm (15 inches)
Pull out approx. 40 cm (15 inches) of labels
and remove the labels from the liner. Lower the
Chapter 3
printhead.
Operation
15