Figure 2-2 Vehicle Battery Cable Jacket - Intermec 4820F User Manual

Installation
Preparing the Vehicle Battery Cable
After you have routed the vehicle battery cable to the ve-
hicle battery, perform the following to prepare the vehicle
battery cable for the terminal ring and fuse link assembly.
The gray vehicle battery cable must be connected according
to the following instructions:
Stripping the Vehicle Battery Cable Jacket
Do the following to strip the gray vehicle battery cable jack-
et and insulation:
1. Cut the gray battery cable near the battery to avoid
2. Strip the battery cable jacket (gray) back 12--14 inches
3. Strip 1/4" (6 mm) of insulation from the black (or
Gray Battery Cable
2-6 4820 Printer User's Guide
coiling or tying excess cable.
(31--36 centimeters).
brown) and red wires.
Red Wire
Black (or Brown) Wire
Figure 2-2
Vehicle Battery Cable Jacket
SECTION 2
$ #
Strip each wire end
1/4 inch (6 mm)
Strip the Cable Jacket
12- -14 inches
(31- -36 centimeters)