Printer Descriptions - Intermec 4820F User Manual

Introduction

Printer Descriptions

Below are the three most common printer configurations:
"
"
"
1-2 4820 Printer User's Guide
Fixed Mount Printer
The fixed mount printer is mounted in motor vehicles
or used in a settlement room environment. The termi-
nal holder may be mounted on the printer or a remote
dock can connect to the side of the printer. A deep pa-
per tray, which holds up to 200 3-ply forms (about 2"
or 5 cm thick) is under the printer mechanism.
Portable Printer
The portable printer has a handle so that you can
carry it. An optional internal battery permits opera-
tion without the use of an external power source. The
terminal holder is an integral part of this printer. A
shallow paper tray, which holds up to 50 3-ply forms
(about an inch or 2.5 cm thick) is under the printer
mechanism.
Wall Mount Printer
The wall mount printer hangs on a mounting plate
secured to a wall. Computers communicate with this
printer only through the remote terminal holder or ve-
hicle dock. There is no internal paper tray, thus paper
is loaded from a separate compact or flat paper tray
(which holds up to 2.5" or 6 cm of paper) or a box. The
printer mechanism is permanently attached. The wall
mount printer cover is hinged to the printer. These
hinges have a tension screw (turn clockwise to tighten,
turn counterclockwise to loosen), should you need to
adjust them.
SECTION 1