Installing Internal Battery; Figure 3-1 Installing Internal Battery - Intermec 4820F User Manual

Operation

Installing Internal Battery

The optional internal battery (sold separately) is primarily
for the portable printer; it is not for wall mount printers.
The battery can go in some fixed mount printers using a
cable (P/N: 216-756-001) and adapter (P/N: 203-377-001).
The internal printer battery recharges when the printer is
connected to an external power source via the power cable.
This battery does not charge the computer.
" NOTE:
Remove the printer battery when storing a printer for over 30 days.
After storage, reinstall the battery and connect the printer to an ex-
ternal power source for at least two hours, to recharge the battery.
1. Unlatch (pull inward) and lift open the printer mecha-
2. Attach the battery cable to the battery as you push
3. Close and latch (push outward) the printer mechanism
2
1
3-2 4820 Printer User's Guide
nism, then lower the battery into the rear of the print-
er case.
the battery down and back into the case, as shown.
into place.
3
1. Battery cable
2. Battery (top edge)
3. Printer mechanism (raised)
4. Latches
Figure 3-1
Installing Internal Battery
SECTION 3
4