Intermec 4820F User Manual page 28

Installation
Connecting to the Vehicle Battery
Your vehicle would have either a top-mount battery with its
bolts on the top; or a side-mount battery with its bolts on
the side. Determine which battery is in your vehicle and
proceed with the following applicable instructions:
Connecting to Side-Mount Battery Terminals
Do the following to attach the vehicle battery cable to a
side-mount battery terminal:
1. Disconnect the negative battery terminal cable.
2. Remove both battery terminal screws from the vehicle
3. Screw a 3/8" nut (2) as far as it will go onto a 3/8" x
4. Slip a 3/8" washer (6) onto the bolt.
5. Slide the positive (red wire with fuse link (5)) terminal
6. Slip a second 3/8" washer (6), then slip the vehicle
7. Thread the bolt assembly (steps 3--6 above) into the
8. Securely tighten the bolt, then the nut (2) installed in
" NOTE:
Repeat steps 3- -8 for the negative vehicle battery cable wire (black
or brown), hooking up the negative cable to the negative battery ter-
minal.
9. Reconnect the negative battery terminal cable.
2-8 4820 Printer User's Guide
battery cable.
1-1/2" bolt (1) furnished in the kit.
ring from the vehicle battery cable onto the positive
(+) battery terminal bolt.
positive battery cable (4) onto the bolt.
positive battery terminal.
step 3 to secure washers (6) and cables into place.
SECTION 2