Figure 2-6 Clamps - Intermec 4820F User Manual

Installation
Securing the Vehicle Battery Cable
1. Secure the vehicle battery cable every 18" ( 50 cm)
2. Remove the paper backing from a clamp and stick the
#6 Sheet-metal
Screw Goes Here
Grounding the Printer Power Cable
The printer power cable has a ground strap (or wire) that
must be fastened to vehicle sheet-metal to ensure proper
cable shielding. Follow these steps to fasten the ground
strap:
1. Drill a small hole (to fit the screw) where the chassis
2. Scrape a small circle of paint from around the hole to
3. Use a #8 x 5/8" screw and flat washer to secure the
2-12 4820 Printer User's Guide
with adjustable cable clamps. Work from the battery,
toward the mounting area for the printer.
clamp in place while drilling a pilot hole with a #26
drill bit. Use #6 sheet-metal screws to permanently
hold clamps in place.
Use large clamp to secure op-
tional filter assembly
Figure 2-6
Clamps
ground strap for the power cable connector is to be fas-
tened. Use a punch to dimple and enlarge the hole.
ensure a good electrical connection.
strap.
SECTION 2