Installing A Battery Spacer; Figure 3-2 Spacer Installed In Deep Paper Tray - Intermec 4820F User Manual

SECTION 3 Operation

Installing a Battery Spacer

In the newer printers, smaller battery packs are used.
These smaller battery packs are lighter in weight than the
original and have greater capacity (operating time) than
the original larger batteries. A small metal spacer is
installed over one of the plastic battery retainers built into
the printer to securely fit the smaller battery pack into the
printer.
In a Deep Paper Tray
If you have the deep paper tray (200-sheet), slide the ap-
propriate metal spacer down over one of the plastic battery
retainer clips in the printer as shown. Put the spacer on
the right-hand side of the retainer clip away from the con-
nector end of the battery. On most printers with the deep
paper tray, this is the corner retainer clip, as shown. Other
printers require that you place the metal spacer on the oth-
er retainer clip, located part-way across the printer cavity.
The metal spacer can be removed and relocated if your first
choice interferes with the battery cable and connector.
Figure 3-2
Spacer Installed in Deep Paper Tray
4820 Printer User's Guide 3-3