Configuring Multiple Janus Rf Devices - Intermec JANUS JG2010 User Manual

JANUS 2.4 GHz Installation Utility User's Manual (4MB)
9. A message box asks you if you want to do another installation. Choose Y, if
If you configure your JANUS device to run terminal emulation software, a
terminal emulation session will start after installation is completed and you
reboot the device.

Configuring Multiple JANUS RF Devices

1. A message box appears asking you if you want to install the same
2. If you choose N, the Select a Network/Protocol screen appears. Use the
3. In the Installation Options screen, make any necessary changes to the fields.
4. In the Radio Parameters screen, make any necessary changes to the fields.
5. A message box appears asking if you want to use the shell out feature.
6. Make sure the next JANUS device that you want to configure is connected
7. Follow Steps 1 through 9 in the previous procedure, "Downloading the
3-10
you want to configure another JANUS device. Follow the instructions for
"Configure Multiple JANUS RF Devices" in the next section.
Or, choose N, if you have no more JANUS devices to configure and you
want to exit the Installation Utility. Follow the instructions for "Restoring
the Host PC to the Original Configuration" later in this chapter.
Note: Test the device to make sure it is configured correctly before exiting the
Installation Utility or configuring another JANUS device. If the device is not
configured correctly, choose Y and make the necessary changes.
network/protocol. Choose Y to install the same TE application or SPX/IPX
protocol. Choose N to install another application.
For example, if you installed Intermec TNVTXXX TE on your JANUS
device, the message box contains this message:
Another Intermec TNVTxxx TE Installation? (Y/N)
arrow key to select the type of software that you want to install on the
device and press Enter.
Press F10. The Radio Parameters screen appears.
Press F10.
Choose Y if you need to make changes to your JANUS drive images. When
you are finished modifying the files for your JANUS drive images, type
exit and press Enter to return to the Installation Utility. Or, choose N.
Shell out to DOS before JANUS images built? (Y/N)
to the host PC.
Modified JANUS Drive Images."