Creating A Janus.ini File - Intermec JANUS JG2010 User Manual

11. Select SAVE from the File menu and press
12. Select EXIT from the File menu.
13. Select No when you are prompted to update the online configuration on the
14. Reinsert the Installation Utility disk in drive A on the host PC.
15. Press Alt-F4 on the host PC to exit Intersvr.
16. Type

Creating a JANUS.INI File

For Novell TNVTxxx and NetWare Client for DOS installations, you may want
to create a JANUS.INI file to permanently change your JANUS operating
environment. You can use a JANUS.INI file to enable or disable supported
symbologies or to change other operating parameters such as beep volume,
display, viewport size and movement.
To create a JANUS.INI file
1. Shell out to DOS during the installation process.
2. On the host PC , edit the \IM_FLASH\DRIVEC\AUTOEXEC.BAT file to
3. Save the changed AUTOEXEC.BAT file.
4. At the DOS prompt on the host PC, type this command to start Intersvr.
5. After Intersvr is running, remove the Installation Utility disk from drive A.
Note: You can omit steps 8-11 if you can type X:\IM_FLASH\DRIVEC\J24TE.INI at
the NAME prompt and save the file. Where X is the drive letter on the host PC that
you are mapping to.
JANUS device.
at the DOS prompt on the JANUS device and press
You can now continue with the installation.
change:
d:\ic /l e:\janus.ini
to
d:\ic /l c:\janus.ini
a:intersvr
Note: Drive A must be empty or this process will not work.
B
Helpful Information
.
.
B-11