Advertisement
Table of Contents
- 1 Disassembly and Reassembly Instructions
- 2 Remove Main Logic Board (Mlb)/Display/Frame Assembly from the Case
- 3 Slide off the Board Clips and Separate the Boards from the Frame
- 4 Disconnect the Touch Panel Cable from the MLB and Set Board Aside
- 5 Insert the Board Assembly in the New Display Frame and Reattach the Board Clips
- 6 Using 3M #467 Adhesive Free Film Retape the Display to the New Display Frame
- 7 Insert the Battery Block into the Battery Compartment
- Download this manual
See also:
User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Intermec 600 Series 602
Summary of Contents for Intermec 600 Series 602
- Page 1 602 Upgrade Instructions...
- Page 2 These instructions cover replacing the battery, back cover, board assembly frame, adding a battery block for the new battery, switching the label on the back cover, and unit reassembly. Disassembly and Reassembly Instructions 1. Remove the four (4) back cover screws, 2.
- Page 3 bly from the case. 5. Remove the five (5) board assembly screws. 6. Disconnect the four (4) flex cable connecters. Main Logic Board (MLB) assembly Navigational button connector Screws securing board (4) LCD connector Screw securing board Keyboard (serial interface) con- nectors...
- Page 4 7. Slide off the board clips and separate the boards from the frame. 8. Flip the assembly over and remove the tape securing the touch panel to the frame assembly and the navigational but- ton tape tab from the side of the frame assembly. Board clips (4) Tape attached to all four...
- Page 5 board aside. 10. Remove the display/touch panel assembly and discard old frame. 11. Peel off any remaining adhesive from the CF gasket base. 12. Install the new self adhesive CF gasket (p/n 653-422-001) on the MLB. Touch panel cable Gasket base New CF gasket...
- Page 6 13. Insert the board assembly in the new display frame (p/n 650-717-001) and reattach the board clips. 14. With the display in place, reconnect the touch panel to the MLB. 15. Install the five board assembly screws. New Frame Touch panel connector Board assembly screws Board assembly screw...
- Page 7 kit) retape the display to the new display frame. 17. Install 3 inches of Kapton tape (p/n 906-016-002) over the components where the foam block on the base makes contact. 18. Reconnect the four connectors. Kapton tape covers Q9, C94, C104, and mounting screw.
- Page 8 19. Insert the battery block (p/n 714-511-001) into the battery compartment. 20. Slide in the new battery (p/n 317-107-002) and connect the cable. 21. Carefully Peel off the part/serial number label from the outside of the old base cover and attach it to the new base cover (p/n 650-716-002).
Need help?
Do you have a question about the 600 Series 602 and is the answer not in the manual?
Questions and answers