Table of Contents
Advertisement
JANUS 2.4 GHz Installation Utility User's Manual (4MB)
Understanding Configuration Parameters
2-4
Use the following configuration parameter definitions when you fill in fields on
the terminal selection, character set, network, and radio parameters screens.
Terminal Selection Screen
Use the Choose a Device to Configure screen to specify the type of JANUS
device that you want to configure.
Network/Protocol Selection Screen
If your JANUS device is going to emulate a terminal, use the Select a
Network/Protocol screen to specify the terminal type. The Installation Utility
will load the appropriate terminal emulation application. Refer to the JANUS
2.4 GHz Terminal Emulation Quick Reference Guide for information about using
Intermec terminal emulation software.
Note: If you configure your JANUS device to run terminal emulation software, a
terminal emulation session will start after you complete the installation and reboot the
device. If you do not want the terminal session to start, you need to modify your
APP.BAT file or you can add a REM before the statement in the AUTOEXEC.BAT file
that calls the APP.BAT file.
Intermec TNVTxxx Emulation This Intermec software allows your device to
emulate a VT120/220/320 or ANSI terminal using a telnet session.
Advertisement
Table of Contents
