Configuring Your Janus Rf Device; Using Rf Communications - Intermec Janus 900 Quick Reference Manual

Troubleshooting Your J2050 (continued)
Problem
RF communications appear to be locked
up and the Connect LED turns off.

Configuring Your JANUS RF Device

There are three ways you can configure the RF configuration parameters on
your JANUS RF device:
Each one of these methods is described in this section.

Using RF Communications

Once you have initially configured the JANUS RF device for your system, you
can change the JANUS RF device's configuration by transmitting configuration
command strings over the RF link to the IRL Desktop or any application that
specifically uses Reader Services' input manager. Your JANUS PSK reference
manual describes how to use Reader Services.
The following configuration parameters can be changed by transmitting
commands to the JANUS RF device over the RF link:
JANUS 900 MHz Radio Frquency Quick Reference Guide
Solution
There are three possible solutions:
1. Make sure you are within range of a radio repeater or base
radio unit.
2. Press the
that does not work, perform a warm boot on the J2050 (press
the
Intermec service representative. When you warm boot the
J2050, you will lose any data stored in the RF interface.
3. Press the
Press the
Loader menu, select Storage mode. With the J2050 in storage
mode, wait 60 seconds and then press
sequence will cold start the radio, reboot the JANUS RF
device, and restart the application.
Use RF communications to change a few parameters.
Use the Interactive Configuration application (IC.EXE).
Scan bar code labels.
Acknowledgment Delay
Duty Cycle Percent
Duty Cycle Period
Nuggetfont
button twice to partially reset the RF interface. If
keys in sequence) and contact your
- -
button. Press
button to turn the J2050 back on. At the Boot
and then press .
again. This
17