This chapter explains how to use the Installation Utility to configure one or more
JANUS RF devices. For more detailed information about these procedures, see
Chapter 2, "Preparing to Run the Installation Utility."
Starting the Installation Utility
Configuring the First JANUS RF Device
For help understanding any of the processes or parameters, see Chapter 2,
"Preparing to Run the Installation Utility."
Choosing the Configuration Parameters
1. The Choose a Device to Configure screen is the first to appear. Use the
2. The Select a Network/Protocol screen appears. Use the arrow key to select
At the DOS prompt of your host PC, type this command and press Enter.
a:install
arrow key to select the type of JANUS RF device that is connected to your
host PC and press Enter.
the type of software that you want to install on the device and press Enter.
Running the Installation Utility
3
3-3