Configuring Multiple Janus Rf Devices - Intermec JANUS JG2010 User Manual

Do you want to shell out to DOS and reduce number of files? (Y/N)
To correct this problem, choose Y to shell out to DOS. Delete files from
\IM_FLASH\DRIVEC. This message will keep repeating each time you type
exit until you create enough free disk space for the drive C image.

Configuring Multiple JANUS RF Devices

After the Installation Utility has configured your first JANUS device, a message
box asks you if you want to do another installation.
At this point, you can:
Intermec recommends that you test the device before you exit the Installation
Utility or before you configure other JANUS RF devices. If the device is not
configured correctly, proceed with another installation and change the
parameter that is causing the failure (for example, incorrect domain, IP address,
etc.).
If you choose to configure another JANUS device, a message box asks you to
confirm the type of installation you want to perform. If you choose Y, the
Installation Options screen appears again. You are not be able to change the
options in the first four fields. During the same installation, each device must
be configured for the same network software, version, path, and flash image
drive. Depending on your network software, you can change the following
parameters:
Configure another JANUS RF device.
Save your drive images so that you can configure another JANUS device
later.
Preparing to Run the Installation Utility
2
2-13