Table of Contents
Advertisement
JANUS 2.4 GHz Installation Utility User's Manual (4MB)
If you select a non-U.S. character set, these actions are performed when the
AUTOEXEC.BAT file is processed:
Switching Between Keypads
Use the following commands to switch between keypad configurations on your
JANUS RF device.
Conventional Memory Required
Configuring for international character sets requires an additional 17K to 35K
of conventional memory on your JANUS device.
About the Network Parameters
Use the Installation Options screens to enter the network parameters for FTP
PC/TCP for DOS, NetWare Client for DOS or LAN WorkPlace for DOS and the
radio parameters. At this point, the utility checks to make sure that you have at
least 14MB of hard disk space available on your host PC.
The Installation Options screen that appears depends on which terminal
software option you chose in the Terminal Selection screen.
2-6
The appropriate code page is selected.
The appropriate code page is prepared.
The KEYB.COM program is loaded to replace the current keyboard driver.
> < G
to switch to the U.S. keypad.
> < H
to switch to the keypad driver installed for the country you
selected.
LAN WorkPlace for DOS. This screen appears if you choose to load
software that uses TCP/IP (Intermec TNVTxxx, 3270 or 5250, or Novell
TNVTxxx).
NetWare Client for DOS. This screen appears if you choose to load software
that uses SPX/IPX (NetWare Client).
FTP PC/TCP for DOS. This screen appears if you choose to load software
that uses PC/TCP for DOS.
Advertisement
Table of Contents
