Configuring The Backlight Settings - Intermec CN4 User Manual

Configuring the Backlight Settings

CN4 Series Mobile Computer User's Manual
If the touch screen is so out of alignment that you cannot open the
Start menu, you may need to align the screen menu using only the
keypad, or as a last resort you can perform a clean boot. For more
information about performing a clean boot, see
CN4" on page 85.
To align the touch screen using the keypad
1 Press the Windows button on the upper left of the keypad.
2 Press the Down button to select Settings.
3 Press Enter.
4 Press the Tab button until the Settings tabs are highlighted.
5 Press the Right Arrow button to select the System tab (on some
keypads this will be the orange button and down button).
6 Press tab until the Screen icon is highlighted.
7 Tab to Align Screen and press Enter follow the instructions to align
the screen.
8 Click ok.
By default, the CN4 goes into Screen Off mode when there is no
activity on the computer. Screen Off mode turns off the backlight and
display. Press a key or tap the screen to resume activity.
It is possible to override the backlight settings by changing the power
management settings. For more information on configuring power
management, see the next section, "Managing Power on the CN4."
To configure the backlight
1 Tap Start > Settings > the System tab > Backlight > the Battery
Power tab.
2 With Turn off backlight if device is not used for checked, select
the timeout value (10 seconds, 30 seconds, or 1 to 5 minutes).
Chapter 1 — Using the CN4
"Clean Booting the
23