Safety, Noise And Vibration Plates; Position Of The Safety Plates; Safety Plates - Komatsu SK818-5 Operation & Maintenance Manual

SAFETY, NOISE AND VIBRATION PLATES

2.1 SAFETY, NOISE AND VIBRATION PLATES

2.1.1 POSITION OF THE SAFETY PLATES

The safety plates must always be legible and in good conditions; for this reason, if they are dirty with dust, oil or
q
grease, it is necessary to clean them with a solution made of water and detergent.
Do not use fuel, petrol or solvents.
If the plates are damaged, ask for new ones to Komatsu or to your Komatsu Dealer.
q
In case of replacement of a component provided with a safety plate, make sure that this plate is applied also on
q
the new part.
The machine can be provided with other plates in addition to those indicated below; in any case, keep also to the
q
instructions given in the additional plates.

2.1.1.1 SAFETY PLATES

RWA37010
16
RWA00030