Table of Contents
Advertisement
HAND & FOOT CONTROL SYSTEM
6.5.2 HOW TO MOVE THE MACHINE (HAND & FOOT CONTROL SYSTEM)
Before moving the machine, make sure that you know the control functions and all the relevant safety
q
regulations perfectly.
The operator must be seated in driving position with fastened safety belt and lowered safety bars.
q
Before moving the machine, check the position of the rear-view mirrors (if installed) and make sure that
q
there is no one within the operating radius of the machine and that there are no obstacles in the sur-
rounding area.
Be extremely careful when engaging the reverse and make sure that there are no persons, other equip-
q
ment or obstacles in the way.
Avoid any travel manoeuvre or change of direction with the accelerator at maximum speed, since ma-
q
noeuvres carried out in these conditions may cause dangerous movements.
Do not use the speed increase function when changing direction or carrying out a counter-rotation.
q
The speed increase function must be used only for travelling at high speed
Before moving the machine, after checking the instruments and heating the engine and the hydraulic system oil,
make sure that the control safety device is released (safety bars lowered) and that the bucket is folded; the equip-
ment control pedals must be in neutral position. At this point, release the parking brake.
1 - Pull the manual accelerator lever and run the engine at
idle speed.
236
WARNING
RKA10510
Advertisement
Table of Contents
