Table of Contents
Advertisement
USING THE WORK EQUIPMENT
3.13.7 CHANGING THE BUCKET OR THE EQUIPMENT WITH OPTIONAL
RAPID COUPLING
Stop the machine on a firm and level surface and lower the equipment to the ground.
q
Before getting off the machine, stop the engine, release the residual pressure by moving the equipment
q
control lever more than once in all directions and lock the controls (safety bars lifted in vertical posi-
tion).
Clean the upper and lower areas involved in the installation of the bucket or the equipment, removing
q
any trace of dirt or debris, before connecting or disconnecting them to/from the rapid coupling.
Before starting work, make sure that the rapid coupling pins are completely engaged, that they protrude
q
from the tabs (slots) provided on the bucket or on the equipment and that the coupling levers are lowe-
red in horizontal position.
After locking the equipment and before starting work, make sure that the locking pins are correctly en-
q
gaged and that the length of the protruding parts of the pins is in compliance with the prescribed safety
values (see "3.13.7.3 CHECKING THE POSITION OF THE LOCKING PINS").
Lubricate the levers as required and remove any dirt or debris. Lubricate the connection pins as requi-
q
red and keep the area around the pins free of dirt and debris. Always grease the pins with the bucket re-
sting on the ground. Grease according to the routine maintenance schedule or when changing the
bucket.
Avoid using your fingers to align the holes, since they may be cut in case of sudden or uncontrolled mo-
q
vements.
The loader has been designed in such a way as to allow va-
rious types of buckets or special equipment to be installed.
To facilitate the change procedure, the machine is equipped
with a special universal tool carrier, called "PAN-TACH", which
makes it possible to install and remove the bucket or the equi-
pment by means of spring-loaded levers and a pin latching sy-
stem that secures the machine coupling to the bucket or the
equipment.
LOCKING THE BUCKET OR THE EQUIPMENT
Rotate the levers (1) downwards in horizontal position.
RELEASING THE BUCKET OR THE EQUIPMENT
Rotate the levers (1) upwards in vertical position.
For the installation of equipment not described in this
q
manual, read and keep to the instructions given in the
user's manual supplied by the manufacturer of the equi-
pment in question.
138
CAUTION
WARNING
2
1
2
1
RWAA9970
RWAA9960
Advertisement
Table of Contents
